1 Litre Lubricant Bottle Mould
Two-cavity blow mould for a one litre lubricant bottle, shown with its cavity and backing halves.
- Cavities
- 2
- Capacity
- 1 litre
- Material
- Tooling steel
5 Litre Jerry Can Mould
Two-cavity blow mould for a five litre stackable jerry can, with Beryllium Copper at the neck and the base pinch-off.
| Cavities | 2 |
|---|---|
| Capacity | 5 litre |
| Material | Tooling steel |
| Inserts | Beryllium Copper — neck and pinch-off |
| Process | Blow Moulds |
The handle and the stacking geometry are the difficult part of a can this size: both have to come out clean while the pinch-off stays sharp over a production run. Beryllium Copper inserts at the neck and the base take heat out of exactly those areas.
Lead time is quoted per project with a dated schedule, not estimated here.
Related tooling
Built alongside this one.
750 ml Bottle Mould
Single-cavity blow mould for a 750 ml bottle, cut in Alumec.
- Cavities
- 1
- Capacity
- 750 ml
- Material
- Alumec
6-Cavity Pharmaceutical Bottle Mould
Six-cavity bottle mould, photographed on the machine with the cavities polished.
- Cavities
- 6
- Geometry
- Matched across all cavities